You don't want to drill or screw to install your smoke detector, heat detector or CO detector? Then you should use this handy magnetic assembly kit for fire alarms!
Properties
- 7cm diameter
- 2,1kg supporting power
- 2 magnets with special, powerful 3M-tape
- Fits all autonomous smoke- and heat detectors
- Don't drill or screw: perfectly suited for caravans, boats, concrete ceilings...
- Instal your detector in 10 seconds
- Can also be attached to a wall (but ceiling mount for detectors is still recommended!)
- Not suited on: vinyl, wallpaper, polystyrene, non-stick and silicone protective layers
- Not suited for 230V detectors (electricity)
Installation instructions: important!
- Installation must be completely dust-free
- Only install on a completely smooth, grease- and dust-free surface
- Only install in dry rooms
- When sticking, always press firmly for at least 10 seconds over the entire surface
- Make sure that the two magnet plates are always completely pushed over each other
